How to tear off the protective film of aluminum plate?
Aug 04, 2022
Since the appearance of aluminum sheet in the late 1980s and early 1990s, it has been rapidly received by its economy, variety of optional colors, convenient construction methods, excellent processing performance, excellent fire resistance and noble quality. people's favor. Aluminum panels have played a major role in building exterior walls, curtain wall panels, renovation and renovation of old buildings, interior wall and ceiling decoration, advertising signs, display stands, purification and dustproof projects, etc., but many people have found that over time, The protective film on the aluminum plate is difficult to tear off, so how to tear off the protective film on the aluminum plate?
The side of the protective film on the surface of the aluminum composite panel that is in contact with the aluminum composite panel is coated with a layer of glue and has a certain viscosity. Under normal circumstances, the protective film is relatively easy to tear off. If the protective film on the surface of the aluminum plate is not easy to tear off, it may be that the aluminum-plastic plate has been stored for too long, and have you taken care of it? It enhances the adhesion with the surface of the aluminum composite panel, making it difficult to tear off. So in view of these situations, how to tear off the protective film of the aluminum plate?
If the aluminum plate is not used for a long time, Delta recommends that you do not use alcohol and other cleaning agents, but be patient and slowly tear it by hand. The tearing speed should be slow, and the direction of tearing should be at an angle of about 90° to the board surface, so that the viscosity of the protective film will not be reduced. Of course, you can also use a sharp knife to make some parallel marks on the protective film, the width of the parallel lines is about 10cm, but this should be done well, do not scratch the protective film after signing, otherwise it will hurt the aluminum composite panel, you can Do the test on the remaining aluminum composite panel first. But if you don't have a good grasp of it, try not to do it, otherwise the aluminum plate itself will not be worthwhile.
However, if the adhesive layer of the protective film has been in a semi-melted state, then the above method is not applicable. You can try to blow the surface with a blower. Note that the temperature should be moderate, not too high, and the specific temperature should be tested by yourself. , and then slowly tear it, Guangdong Damei New Material Co., Ltd. reminds you that it is good to put a layer of cloth or paper on the protective film of the aluminum composite panel. If the protective film is torn off, there may be some glue left on the board surface, which can be wiped with kerosene or alcohol.
